Suzuki DF9.9B Manuel Du Propriétaire page 19

Install 8 mm bolts, washers, lock washers and
nuts, as illustrated and tighten the bolts sequen-
tially. Be sure to seal the holes with sealant to
prevent water leakage.
Sealant
After installing the motor, check to make sure
that steering and tilt movement are not
obstructed by any part of the boat. Also make
sure that the battery cable (if applicable)
doesn't interfere with movement of the motor.
 WARNING
If the motor is not properly secured to the
transom, it can come off.
Be sure to bolt the motor to the transom.
The motor may come off if it is held only
by the clamp screws. Occasionally check
the clamp screws for tightness.
NOTICE
If you attempt to mount the outboard to
the transom without having mechanical
experience or without being certain
where to drill holes, you can seriously
damage the boat.
If you do not have mechanical experience
or are not sure of where to drill holes in
the boat's transom, you should have your
motor mounted by your authorized
Suzuki marine dealer.
REMOTE CONTROL MODEL
Suzuki strongly recommends that you have
your outboard motor, controls and gauges
installed by your authorized Suzuki Marine
Dealer. He has the tools, the facilities and the
know-how.
 WARNING
Failure to have your outboard motor and
associated controls and gauges properly
installed can result in personal injury or
damage.
Suzuki strongly recommends that you
have your outboard motor, controls and
gauges installed by your authorized
Suzuki marine dealer. He has the tools,
the facilities, and the know-how to do the
job correctly.
17