Corghi A 9222 HP TI Manuel D'utilisation page 43

- Lower the vertical rod until it touches the rim (Fig.
32c).
- Lock the vertical rod in this position.
- Remove valve core and connect the Doyfe con-
nector on the air hose to the valve stem (Fig. 32d).
- Hold the tyre with your hands and lift it until there
is a slight gap between the lower bead and bottom
edge of the rim in order to close the upper bead
and the top of the rim (ig. 32d).
- Fully press the inlation pedal down for a short
period to the bead seating position (ig. 32f). The
tyre will expand and the beads will
seat.
- Release the wheel from the sliding
clamps on the table top (Fig. 32e).
- Inlate the tyre by operating the prop-
er pedal (Fig. 32d) in inlation position
(average) (Fig. 32g) at short intervals;
check the pressure gauge frequently
to make sure that the
pressure NEVER ex-
ceeds the maximum
pressure speciied
by the tyre manu-
facturer.
- Move the swing arm in
its not-working posi-
tion and remove the
tire (Fig. 32h).
A9222 HP TI - A9222 TI - A9824 HP LL - A9824 HP User Manual
32a
32b
YES
32f
32g
32c
32d
NO
32e
32h
43