Corghi A 9222 HP TI Manuel D'utilisation page 40

Don't Lock the rim on the turntable during inlation.
If tires being mounted require more than
the tire manufacturer's maximum bead
seating pressure and, the wheel should be
removed from the tire changer, placed in
an inlation cage, and inlated per manu-
facturer's instructions.
Remove valve stem core if not already done. Connect inlation hose to valve stem.
Step down partially on the pedal to inlate the tyre and seal beads with the inlation hose.
Frequently stop to check bead seating pressure on the gauge.
Avoid personal injury. Carefully read, understand and observe the following instruc-
tions.
1. Overinlated tyres can explode, producing hazardous lying debris that
may result in an accident.
2. Tyres and Rims that are not the same diameter are "mismatched". Never
attempt to mount or inlate any tyre and rim that are mismatched. For example,
never mount a 16" tyre on a 16.5" rim (or vice versa). This is very dangerous.
A mismatched tyre and rim could explode, resulting in an accident.
3. Never exceed the bead setting pressure (gauge on hose) provided by
the tyre manufacturer, as stated on the sidewall of the tyre.
4. Never place your head or any part of your body over a tyre during the
inlation process or when attempting to seat beads.
This machine is not intended to be a restraining device for exploding
tyres, tubes or rims.
5. Always stand back from the tyre changer when inlating, never lean over.
During this operation, noise levels assessed at 85 dB(A) may occur.
Wear hearing protection devices.
A9222 HP TI - A9222 TI - A9824 HP LL - A9824 HP User Manual
40
WARNING
DANGER
WARNING
WARNING