Corghi A 9222 HP TI Manuel D'utilisation page 42

If necessary:
- Continue inlating up to the maximum value
of 3.5 bar to position the tyre correctly on the
rim. Avoid distractions during this operation,
and continually check tyre pressure on the air
pressure gauge (1, Fig. 31a) to prevent excessi-
ve inlation. Inlating tubeless tyres requires a
higher air low-rate to allow the beads to bypass
the rim HUMPS - see types of rim proiles for
mounting without a camera in ig. 31b.
- From the position of the centring ridges check that
the beads are properly positioned on the rim;
otherwise, delate the tyre, break the beads as
described in the relevant section, lubricate and
turn the tyre on the rim. Repeat the mounting operation
described previously and check again.
- Replace the internal mechanism of the valve.
- Bring the pressure to the operating value by pressing
the Inlation push-button (2, Fig. 31a).
- Fit the cap to the valve
9.8.c. INFLATING TUBELESS TYRES
Before carrying out the operations described below, always make sure that there is no
dirt, dust or other impurities on the jaws near the air outlet holes.
- Make sure that the wheel is secured to the table top with inside clamping (Fig. 32a).
- Bring the horizontal arm in its work position (Fig. 32b).
A9222 HP TI - A9222 TI - A9824 HP LL - A9824 HP User Manual
42
WARNING
1
2
"HUMP" (H)
"double HUMP"
(H2)
31
31a
31b