Ecolab EcoPro Manuel D'utilisation page 196

Decommissioning, dismantling, environmental protection
DANGER!
Contact with live components can be fatal
Before commencing dismantling, ensure that the device has been fully isolated
from the power supply. Activated electrical components can make uncontrolled
movements and lead to serious injury.
NOTICE!
Material damage due to using incorrect tools!
Use of the wrong tool can cause damage to property.
Only use the correct tools.
The procedure for dismantling is as follows:
1.
Make sure you have sufficient space before starting all tasks.
2.
Drain operating fluids and consumables and remove the remaining processing
materials; dispose of them in an environmentally friendly way.
3.
Then clean assemblies and components correctly, and dismantle them under
observance of prevailing local health and safety and environmental protection
regulations.
4.
Handle open, sharp-edged components with care.
Suitable protective gloves must be worn.
1.
If present, disconnect the power supply.
2.
Depressurise the system and pressure tube.
3.
Disassemble the components properly.
4.
Remove connections to the peripheral devices.
5.
Be aware of the heavy weight of some components.
If required, use lifting gear.
6.
Support the components to avoid them falling or tipping.
MAN046879 Rev. 12-01.2024 94