Ecolab EcoPro Manuel D'utilisation page 110

General
1.3 Warranty
Our products are built, tested and CE certified in accordance with current
standards/guidelines. They left the factory in a safe, faultless condition.
To keep the equipment in this condition and to ensure risk-free operation,
the user must observe the instructions/warnings, maintenance regulations,
etc. contained in these operating instructions and, if applicable, affixed to the
product. The warranty conditions of the manufacturer apply.
The manufacturer provides a warranty for operational safety, reliability and performance
only under the following conditions:
n Assembly, connection, set-up, maintenance and repair must be carried out by qualified
and authorised specialists.
n EcoPro is used in accordance with the information provided in these operating
instructions.
n Only OE spare parts are to be used for repairs.
n Only approved Ecolab products are used.
1.4 Transportation
NOTICE!
Material damage due to improper transportation!
Transport units can fall or tip over if improperly transported. This may result in
material damage. During unloading, delivery or even during general shipping,
proceed safely and pay attention to the symbols and the information on the
packaging.
Transport inspection:
Examine the delivery for completeness and transportation damages and report
all instances of damage. Damage claims can be filed only within the applicable
period for complaints.
If transportation damage is visible from the outside:
Do not accept the delivery or accept it only under reservation. Note the extent
of damage on transport documents Delivery note of the carrier and initiate a
complaint immediately.
Preserve the packaging (original packaging and original packaging materials)
for possible inspection by the shipper for transport damage or for a return
shipment.
Packaging for returns:
– If both are no longer available:
Call in a packaging company with qualified personnel.
– The packaging dimensions and the weight of the packaging can be found in
chapter
– If you have any questions about the packaging and transport fixings, please
contact the
Danger of putting into operation a piece of transport equipment which
has been damaged during transport:
If damages are discovered during unpacking, do not install or put unit into
operation, as otherwise uncontrollable faults can occur.
MAN046879 Rev. 12-01.2024
Ä Chapter 13 'Technical data' on page 81 .
Ä 'Manufacturer' on page 11 .
8