Ecolab EcoPro Manuel D'utilisation page 109

Safety instructions in the operating instructions
Safety instructions can refer to specific, individual operating instructions. These safety
instructions are embedded in the operating instructions, so they do not interrupt the
reading flow when executing the action. The signal words described above are used.
Example:
1.
Loosen screw.
2.
Close the cover carefully.
3.
Tighten screw.
Other markings
The following markings are used in these instructions to provide emphasis:
1., 2., 3. ...
Step-by-step operating instructions
ð Results of the operating steps
References to sections of these instructions and related documents
Lists in no set order
[Button] Controls (e.g. button, switch), indicators (e.g. signal lights)
'Display' Screen elements (e.g. buttons, assignment of function keys)
The graphics shown in this manual are principle sketches, the actual situation
may differ slightly. Generally, the graphics are structured in such a way that a
principle is recognisable.
Copyright
This manual is copyright protected. All rights belong to the manufacturer.
The transfer of this manual to third parties, reproductions in any kind and form, even in
extracts, as well as the exploitation and/or communication of the content are not permitted
without the written permission of Ecolab Engineering GmbH (hereinafter referred to
as "manufacturer") except for internal purposes. Any violations result in obligatory
compensation for damages.
The manufacturer reserves the right to enforce additional claims.
1.2 Equipment marking – identification plate
Information on equipment marking and information on the rating plate can be
found in chapter
The correct specification of the name and type is important for all queries.
This is the only way of ensuring fast and accurate processing of your enquiry.
CAUTION!
Risk of trapping on the cover!
Ä Chapter 13 'Technical data' on page 81 .
7
General
MAN046879 Rev. 12-01.2024