Hoshizaki SF 950+ Manuel D'utilisation, D'entretien Et D'installation page 16

Baker SF 950+ / 550
THAWING PROGRAM
In connection with thawing, a defrosting heating element is used,
which is governed by the temperature that the room sensor measures.
The thawing program is only able to start when the desired
temperature value is set to between +2 °C and +8 °C.
The program is started by pressing the
When the desired value is attained, an acoustic signal will be emitted. After the signal, defrosting is
commenced (if such is required based upon the evaporator sensor's temperature). Afterwards, the
storage program is switched.
MANUAL DEFROSTING OF EVAPORATOR
Manual defrosting is only possible as initial defrosting:
1) To start a program, press on
2) Press on
commenced.
Do not use mechanical devices or other means to accelerate the defrosting process!
AUTOMATIC DEFROSTING OF THE EVAPORATOR
The unit performs automatic defrosting 1 to 8 times daily, when the "PCL", "HCL" and "SCL"
programs have finished. Defrosting cannot be concluded manually! In connection with this, the
internal temperature inside the unit is shown before the defrosting process commences.
button and wait for 10 seconds.
in order to end/interrupt the program. This will allow defrosting to be
button
ATTENTION
EN
16