Hoshizaki SF 950+ Manuel D'utilisation, D'entretien Et D'installation page 11

Baker SF 950+ / 550
INITIAL DEFROSTING OF THE EVAPORATOR
If the unit is in use and it is cold in the room, the program starts
with a defrosting cycle. In connection with this, the display shows
the temperature internally within the unit. (Do not use
mechanical devices or other means to accelerate the defrosting
process!)
The defrosting symbol is lit up:
STORAGE PROGRAM
If the unit is started in a warm state (normal room temperature
internally inside the unit), then it will immediately switch to the
storage program. In connection with this, the display shows the
temperature internally within the unit. When the storage
program has been activated, only one of the compressors will be
working. The fan will run at a low RPM figure. Hence only one of
the two compressor symbols will be lit. In addition, the symbol
for the evaporator fan will be displayed.
DISPLAY OF THE SETPOINT (TEMPERATURE SETTING) IN THE STORAGE PROGRAM
Press the button, and hold it in.
The display then shows the "desired value" and thereby the
temperature setting.
SETTING OF THE SETPOINT (TEMPERATURE SETTING) IN THE STORAGE PROGRAM
Press the button, and hold it in.
The display then shows the "desired value" and thereby
the temperature setting. When
is lightly pressed (the button continues to be held in), the value
is increased or lowered.
the or button
EN
11