Hoshizaki SF 950+ Manuel D'utilisation, D'entretien Et D'installation page 14

Baker SF 950+ / 550
TEMPERATURE CONTROLLED COOLING (HARD-CHILL)
This program cools down to the selected, desired value at full motor
power (controlled with the use of the extra sensor). Both compressors
perform the cooling in parallel. The second compressor starts 15
seconds after the first one. When the proper evaporator
temperature is attained, the fan will be running audibly with a very high
RPM figure. The program is selected by pressing the button:
After pressing the button, it will be lit continuously. The and buttons will
be blinking. The curve symbol for Hard Chill will light up. The secondary display shows the program
name "PCL", and the tertiary display the selected, desired temperature value. The and buttons
are used to change the desired value, and for starting the program. The primary display
will now show the current temperature in the room, the secondary display the program name "PCL"
and the tertiary display the selected, desired temperature value. The curve symbol is now continuously
displayed. Both compressors, both fan symbols for a high fan RPM figure
When the desired value is attained, an acoustic signal will be
emitted. After the signal, defrosting is commenced (if such is
required based upon the evaporator sensor's temperature). Then it
subsequently switches to the storage program. Hence the desired
value for the storage program must always be set and checked
before starting "PCL"!
14
EN