Nussbaum COMBI LIFT 480H Manuel D'exploitation page 73

Les langues disponibles

System master sheet

2.1 Manufacturer

Nussbaum Automotive Lifts GmbH

Korker Straße 24

D-77694 Kehl-Bodersweier

2.2 Purpose

The automotive lift 4.80 H is a lifting mechanism for lifting motor vehicles with a laden weight of up to 8000 kg . The

max. load distribution is 2:1 either in or against the drive-on direction.

The lift has been designed for stopping under the load receiving fixture. It is not set up for stepping onto the drive-in

rails or for conveying people. The set up of the standard lift is not permitted in explosion endangered work shops and

washing halls.

After construction and maintenance changes on load carrying parts the lift must be inspected afterwards by a specialist

who approves the changes. If the set up location is changed, the lift must be checked again by a specialist and changed

approved.

2.3 Changes to the design/construction

Inspections by a technical expert are required before recommissioning (date, type of change, technical expert signa-

ture).

______________________________________________________________________________________________________

Name, address of technical expert

_________________________________________________

Location, date

2.4 Changing the assembly location

Inspections by a technical expert are required before recommissioning (date, type of change, specialist signature).

______________________________________________________________________________________________________

Name, address of technical expert

_________________________________________________

Location, date

OPI_COMBI LIFT 480H_V4.2_DE-EN-FR-IT – Teile-Nr: 0030173

_________________________________________________

Technical expert signaturer

_________________________________________________

Technical expert signaturer