Publicité
Les langues disponibles
Les langues disponibles
Made
in
Germany
Drive-up direction
5.3 Platform illumination (optional)
There are four lamps integrated on the interior side of the
drive rails to give equal illumination of the work area.
The illumination is switched on via the main switch (a) of
the platform.
5.4 Lifting the vehicle
• During the entire lifting or lowering process, the work
area of the lift should be clear of people and objects.
• Afterwards, lift the vehicle to the desired working height.
Absolutely ensure secure vehicle
placement on the drive-in rails,
otherwise there is a danger of the
vehicle falling.
• Switch on controls at the main switch (a).
• Lift the vehicle. Push the "LIFT" button
• Raise the vehicle to the desired working height.
• The entire lifting process must be continuously observed.
5.5 Set down into the safety ratchets
• Pushing the "Lower into catches" button
the lift down into the next possible catches.
• Keep the "Lower into catches" button
safety ratchets are latched in and the lift can no longer
move downwards.
Before working on the vehicle al-
ways lower the lift into the safety
ratchets.
5.6 Lift out of the safety ratchets
Check the hazardous area around
the platform and ensure that the-
re are no people or objects in the
immediate vicinity of, or on, the
platform.
• Push the "LIFT" button
o
(b) until the catches are released.
5.7 Lowering the vehicle
Check that there are no people or objects in
!
the hazardous area of the lift.
• Push the "LOWER" button
process.
78
o
(b).
(d) sets
u
u
(d) until all four
u
(c) to start the lowering
• The lift moves approx. 10 cm upwards to release the 4
safety ratchets which are then electrically retracted.
• Lower the lift to the desired position.
• The entire lowering process must be continuously ob-
served.
• Shortly before reaching the lowest position the lift au-
tomatically switches off to prevent crushing in the foot
area (CE STOP).
• Thereafter the "LOWER" button
again. An acoustic warning signal sounds during lowe-
ring until the floor is reached.
• Once the lift is at the lowest position, the vehicle can be
driven off the lift.
5.8 Safety switch below the drive rails
The lift has a safety switch (4) fitted below the drive-in rails
used to monitor the cables. This triggers if,
• a cable breaks
• the lift moves onto an obstacle and the cable loosens
• only one safety ratchet has a catch latched in and the
cable is loose.
i
The lift then remains in place with no functionality.
5.9 Adjusting the platform
• It is possible to adjust the rail of the different wheelba-
se. That is necessary to reach the different wheelbases
of the vehicles. One platform is only movable without
load. The measure 850 – 1150 mm between the plat-
form can be reached.
• Remove the load and raise the lift on approx.1000 mm
height. The platform is movable into the chosen position
without high force.
6
Behavior in cases of error
Defective operational readiness of the system may be due
to a simple error. Check the system for the listed sources
of error.
If the error cannot be removed after an inspection to the
named causes, then inform customer service or your dea-
ler.
Independent repair work on safety
devices of the lift and checking the
electrical system may only be done
by specialists.
Problem: Motor does not start!
Possible causes:
No power supply
Main switch is not enga-
ged
OPI_COMBI LIFT 480H_V4.2_DE-EN-FR-IT – Teile-Nr: 0030173
u
(c) must be pushed
Remedy:
Check the power supply
Check the main switch
Publicité
