Personnel Qualifications; Electrical Work; Operator Responsibilities - Wilo Stratos MAXO-D 32/0,5-12 Notice De Montage Et De Mise En Service

1.6.2

Personnel qualifications

1.6.3

Electrical work

1.6.4

Operator responsibilities

Installation and operating instructions Wilo-Stratos MAXO/-D/-Z
Guidance information
▪ Safety instructions relating to property damage start with a signal word and are dis-
played without a symbol.
Signal words
▪ Danger!
Failure to observe safety instructions will result in serious injury or death!
▪ Warning!
Failure to follow instructions can lead to (serious) injury!
▪ Caution!
Failure to follow instructions can lead to property damage and possible total loss.
▪ Notice!
Useful information on handling the product
Symbols
These instructions use the following symbols:
General danger symbol
Danger of electric voltage
Warning of hot surfaces
Warning of magnetic fields
Notices
Personnel must:
▪ Be instructed about locally applicable regulations governing accident prevention.
▪ Have read and understood the installation and operating instructions.
Personnel must have the following qualifications:
▪ Electrical work must be performed by a qualified electrician.
▪ The installation/dismantling must be carried out by a qualified technician who is trained
in the use of the necessary tools and fixation materials.
▪ The product must be operated by persons who are instructed on how the complete sys-
tem functions.
▪ Maintenance tasks: The technician must be familiar with the use of operating fluids and
their disposal.
Definition of "qualified electrician"
A qualified electrician is a person with appropriate technical education, knowledge and
experience who can identify and prevent electrical hazards.
▪ Electrical work must be performed by a qualified electrician.
▪ Nationally applicable guidelines, standards and regulations as well as specifications is-
sued by the local energy supply companies for connection to the local power supply
system must be observed.
▪ Before commencing work, disconnect the product from the mains and safeguard it from
being switched on again.
▪ Personnel must be trained on executing the electrical connection and the options for
switching off the product.
▪ The connection must be protected by means of a residual-current device (RCD).
▪ The technical specifications contained in these installation and operating instructions
and on the rating plate must be complied with.
▪ The product must be earthed.
▪ When connecting the product to an electrical switching system, the switchgear manu-
facturer's specifications must be observed.
▪ Have defective cables replaced immediately by a qualified electrician.
▪ Never remove operating elements.
▪ If radio waves (Bluetooth) lead to hazards (e.g. in hospitals), they must be switched off
if they are not desired or prohibited at the installation location.
Operators must:
▪ Provide the installation and operating instructions in a language which the personnel
can understand.
en
117