Hettich ROTINA 380 Mode D'emploi page 104

Software operation
7.2 Programming
7.2.1 Preset programs (for type 1701-30 only)
PROG 1
RAD 155
RCF 200
RPM 1074
Runtime 2:15
Start-up 9
stage
Brake level 0
7.2.2 Write protection for programs
7.2.3 Opening or loading programs
38 / 63
Programs 1 to 4 are preset and write-protected.
When trying to save data to program locations 1 to 4,
'Protected !!' is displayed and the data is not saved.
When the program is retrieved, '+' indicates that this data is
write-protected for program locations 1 to 4.
Data can be changed and saved to program locations 1 to
4 if the write protection is removed. However, the storage
is only temporary and the changed data will be lost again
after the device is switched off.
PROG 2
RAD 155
RCF 800
RPM 2149
Runtime 10:15
Start-up 9
stage
Brake level 6
Write protection can be enabled or disabled when the rotor is at a standstill.
1. Open the desired program.
[PROG] button.
2. Press the
�� The RCL parameter is displayed.
3. Press and hold the
�� The STO parameter is displayed.
'Set Protection = 1-' is displayed after 8 seconds.
[Rotary knob] to set '+' or '-' .
4. Use
+ = The program is write-protected
- = The program is not write-protected
[START] button.
5. Press the
�� The setting is stored.
1. Press the [PROG] button.
�� The RCL parameter is displayed.
[Rotary knob] to set the desired program location.
2. Use the
Rev.: 16 / 11.2023
PROG 3
RAD 155
RCF 600
RPM 1861
Runtime 10:15
Start-up 9
stage
Brake level 6
[PROG] button.
PROG 4
RAD 155
RCF 600
RPM 1861
Runtime 5:15
Start-up 9
stage
Brake level 6
AB1701en