Steinberg Nuendo DD8 Mode D'emploi page 12

The ADAT/TDIF to AES section is layed out in a similar way. After choos-
ing the input signal (AES, ADAT or TDIF), the clock source and the sam-
pling rate, there is a field with 16 LEDs for displaying the output state.
An Emphasis bit at the TDIF input will be automatically set and indi-
cated for the AES out. The lock state of the input signals is being dis-
played at the Input selector by flashing LEDs. The sync LEDs show the
synchronicity between both ADAT or TDIF inputs, as in double speed
mode (DS) 2 I/Os are active (4 channels each). The AES output signal
can also be set to Consumer subcode. The first output (channel 1/2) can
optionally be output optically (via TOSLINK) using the ADAT AUX port.
The unit always sends its output signal to ADAT and TDIF simultane-
ously. Additionally when operating at no higher than 48 kHz both
ADAT outputs and TDIF interfaces get the same signal. Thus the distri-
bution capability is doubled to 2 x ADAT and 2 x TDIF. Thanks to the
possibility to freely select between inputs, all attached devices can
send signals to each other without the need to rearrange the cabling
between them.
NUENDO DD 8
English – 12