Publicité
Les langues disponibles
Les langues disponibles
Parts and their functions
Encoder control area
Encoder and systems adjustments can be performed using these controls for the video signals to be output to an
external device.
<Note>
The VTR2 controls are positioned symmetrically to the VTR1 controls.
1 VIDEO LEVEL control
Used to adjust the video level of the video output
signals.
2 SET UP control
Used to adjust the setup level of the video output
signals.
3 HUE control
Used to adjust the hue of the video output signals.
4 CHROMA LEVEL control
Used to adjust the chroma level of the video output
signals.
5
4
COARSE
FINE
H
CHROMA
SC
SYSTEM
LEVEL
VTR1 controls (side panel)
(VTR1)
23
3
2
1
VIDEO
HUE
SET UP
LEVEL
5 SYSTEM controls
Used to perform the system adjustments when a
reference video signal is to be input for
synchronization purposes.
H: Used to adjust the system's horizontal phase (in
subcarrier cycle increments).
SC FINE:
Used to adjust the system's subcarrier phase.
(It is capable of 90-degree P-P continuous
adjustments.)
SC COARSE:
Used to adjust the system's subcarrier phase.
(It has 4 positions, each of which corresponds to
90 degrees.)
<Note>
It may not be possible to adjust the phase in the 625i
mode even when the system adjustments at the VTR1
side are performed.
Publicité
