Panasonic DVCPRO50 AJ-LT95P Manuel D'instructions page 76

Setting the time code
When performing assemble editing or
time code insert editing by presetting the
user's bit
1
Align the cursor with setup menu item No.574 (UB
PRESET).
2
Press the T SET ([SHIFT] + [3]) button.
3
Use the numeric input buttons to input the desired
user's bit value.
4
Press the ENTER button.
5
Select "SW" as the setup menu item No.504
(REGEN MODE).
6
Set the TC generator switch of VTR2 to R-RUN or
F-RUN.
7
Proceed with the assemble editing or time code
insert editing.
<Note>
To input letters A through F, press the SHIFT button
and one of the following number buttons.
A ([SHIFT] + [1])
B ([SHIFT] + [2])
C ([SHIFT] + [3])
D ([SHIFT] + [4])
E ([SHIFT] + [5])
F ([SHIFT] + [6])
(T SET)
76