Panasonic DVCPRO50 AJ-LT95P Manuel D'instructions page 85

Superimposed screen
Characters and symbols can be superimposed onto
the output signals from the unit's liquid crystal monitor
or VIDEO MONITOR OUT connector.
This superimpose function can be turned ON or OFF
by pressing the DISP ([SHIFT] + [0]) button.
The information to be superimposed and displayed
can be selected using setup menu item No.002
(DISPLAY SEL).
$ TIME mode
In this mode, the counter value is displayed on one
line.
T C R 1 2 : 3 4 : 5 6 : 2 1
$ T&STA mode
In this mode, the counter value and VTR's
operating mode are displayed on two lines.
T C R 1 2 : 3 4 : 5 6 : 2 1
S H T L + 3 2 . 0
$ T&S&STA mode
In this mode, the counter value, VTR's operating
mode and remaining tape amount are displayed on
three lines.
T C R 1 2 : 3 4 : 5 6 : 2 1
S H T L + 3 2 . 0
D V C P R O 5 0
Information displayed on TIME line
T T C C R R 1 1 2 2 : : 3 3 4 4 : : 5 5 6 6 : : 2 2 1 1
: (colon) = Non-drop frame mode
. (period) = Drop frame mode
: (colon) = Normal mode
. (period) = Time track mode
CTL: Control signal
TCR: Time code reader value
T¢ ¢ R: Time code reader value (when reading has failed)
UBR: User's bit value (no colon on counter when this is
displayed)
U¢ ¢ B: User's bit value (when reading has failed)
Information
operating mode) line
R 8 2
Information displayed on MODE line
O Tape format
R 8 2
O Error messages
85
displayed
o o m m S S H H T T L L + + 3 3 2 2 . . 0 0
Search speed and direction
O The tape speed is displayed during
SHTL, VAR and PPLY.
O The direction is displayed during jog or
EXT VTR control (REV, STILL, FWD).
VTR operations
EJECT, STOP, REW, FF, STANDBY OFF, PLAY, REC,
EDIT, E PLAY, SHTL, JOG, VAR, PPLY, POWER OFF,
AUTO OFF and DEW
<Note>
When the tape beginning or end has been detected,
BOT (beginning of tape) or EOT (end of tape) is
displayed at the head of the line.
Display examples:
O EOT STOP (STOP mode at the end of the tape)
O BOT STANDBY OFF (STANDBY OFF mode at the
beginning of the tape)
This appears when voice-over or audio cross channel editing
has been set.
This appears when 20 seconds have elapsed after the
commencement of input audio data writing in the internal memory
in the course of a voice-over operation, and it indicates that the
memory is now full.
This displays the format of the cassette tape.
Display example: DVCPRO 50
A warning message or the AUTO OFF message appears when
an error has occurred.
For further details, refer to the error messages (pages 86, 87).
on STATUS (VTR's
R R 8 8 2 2
Remaining tape amount
O It appears when ON has
been selected as the setup
menu item No.003 (REMAIN
SEL) setting.
O It does not appear when
BOT or EOT is displayed
(when the tape beginning or
end has been detected)