Publicité
Les langues disponibles
Les langues disponibles
Setup menus
EDIT menu
Item
Superimposed
No.
display
370
BEEP
371
SV-UNLK EDIT
372
SYNCHRO EDIT
373
SYNCHRO
374
EDL AUTO CLR
375
SPLIT EDIT
376
1ST EDIT DUR
377
1ST EDIT TC
378
1ST EDIT UB
The underlining indicates the factory setting.
Setting
Superimposed
No.
display
This selects whether the confirmation tone is to be sounded.
0000
OFF
0: The confirmation tone does not sound.
0001
ENTRY
1: The confirmation tone is sounded when registering is performed
or when an error or warning has occurred.
0002
ALL1
2: The confirmation tone is sounded when registering is
performed, when an edit IN or OUT point is passed or when an
error or warning has occurred.
0003
ALL2
3: The confirmation tone is sounded when registering is
performed, when an edit OUT point is passed or when an error
or warning has occurred. It does not sound when an edit IN
point is passed.
This selects in what editing mode the editing is to be suspended
when servo lock is not engaged.
0000
EDIT
0: Editing is not suspended and is continued.
0001
ABORT1
1: Editing is suspended when the servo lock is not engaged in the
editing run-up period.
0002
ABORT2
2: Editing is suspended when the servo lock is not engaged in the
editing run-up period or after edit recording mode has been
suddenly established.
This selects whether editing is to be suspended if phase
synchronization cannot be achieved at an accuracy of ±0 frame
when the SYNCHRO setting is ON.
0000
OFF
0: Editing is not suspended.
0001
ON
1: Editing is suspended.
This sets the VTR for which the phase is synchronized.
0000
VTR1
0: Phase is synchronized for VTR1.
0001
VTR2
1: Phase is synchronized for VTR2.
This selects whether to clear the first event and overwrite the
subsequent events successively when the EDL is full with
registered events.
0000
OFF
0: Events cannot be overwritten.
0001
ON
1: Events can be overwritten.
This selects the split editing reference.
0000
AUDIO
0: The video edit points are used as the reference for audio split
editing.
0001
VIDEO
1: The audio edit points are used as the reference for video split
editing.
This selects the time during which the black burst signal is to be
recorded during 1ST EDIT.
0000
26s
0: The signal is recorded for 26 seconds, after which the tape is
reversed for 3 seconds and stopped. The point at which the
tape has stopped serves as the point which is set by 1ST EDIT
PRESET.
0001
T-END
1: The signal is recorded to the tape end or the position where the
tape is stopped by ALL STOP. When it is recorded to the tape
end, the tape is automatically reversed to the 1ST EDIT
PRESET position.
This selects the time code preset value during 1ST EDIT.
00:00:00:00 to 23:59:59:29 (525i mode)
00:00:00:00 to 23:59:59:24 (625i mode)
This selects the user's bit preset value during 1ST EDIT.
00:00:00:00 to FF:FF:FF:FF
38
Description of setting
V
V
T
T
R
R
1
2
[
[
[
[
[
[
[
[
[
Publicité
