Publicité
Les langues disponibles
Les langues disponibles
22
EN
Engage the blade with the cutting deck in the highest position, and then gradually low-
er to the height required. To achieve good collection and even cutting of the grass,
choose a forward speed to suit the quantity of grass to be cut (height and density) and
the lawn's humidity, in line with the following indications (
dels):
– High and dense grass - wet lawn
– Average condition grass
– Low grass - dry lawn
NOTE
horizontal surfaces.
Hydrostatic transmission
The speed has to be adapted to the condition of the grass in a gradual and progres-
sive way by moving the speed change lever.
The speed should always be reduced if you note a reduction in engine speed, since a
forward speed that is too fast will not cut the grass well.
Disengage the blade and put the cutting deck in the highest position whenever you
need to get past an obstacle.
5.3.2 Cutting height adjustment
The height is adjusted by moving the lever with 7 height positions.
5.3.3 Lawn maitenance
1.
To keep a lawn green, soft and attractive, it should be cut regularly without dam-
aging the grass. A lawn can be composed of different types of grass. If the lawn is
cut frequently, grass and roots grow more vigorously, forming a solid grassy bed.
If the lawn is cut is less frequently, higher grass and weeds start growing (plus
daisies and clovers, etc.).
2.
It is always better to cut the grass when dry.
3.
The blades must be in good condition and well sharpened so that the grass is cut
straight without a ragged edge that leads to yellowing at the ends.
4.
The engine must run at full speed, both to ensure a sharp cut of the grass and to
get the necessary thrust to push the cuttings through the collector channel.
5.
The frequency of mowing should be in relation to the rate of growth of the grass.
The grass should not be left to grow too much between one cut and the next.
6.
During hot and dry periods, the grass should be cut a little higher to prevent the
ground from drying out.
All manuals and user guides at all-guides.com
The fifth gear is solely for moving from one area to another on
HOW TO USE THE MACHINE
for mechanical drive mo-
1st speed
2nd - 3rd speed
4th speed
Publicité
