Publicité
Les langues disponibles
Les langues disponibles
10
EN
Follow the instructions given.
Put the column covers (3) and (1) back on with
their screws (4) and (2).
Charge the battery following the battery manufac-
turer's instructions.
IMPORTANT
in the electronics card from cutting in, never start
the engine until the battery is fully charged!
WARNING!
facturer's instructions regarding safe han-
dling and disposal.
3.3 FITTING THE STEERING WHEEL
Put the machine on a flat surface and straighten up
the front wheels.
Fit the steering wheel (1) onto the protruding shaft (2)
with the spokes directed towards the seat.
Line up the hole in the steering wheel hub with the
hole in the shaft and insert the pin supplied (3).
Push the pin in using a hammer, ensuring that it
comes completely through to the opposite side.
NOTE
awl or a screw-driver of the same size as the pin to push it in the last part.
3.4 FITTING THE SEAT
Fit the seat (1) onto the plate (2) using the screws (3).
3.5 FITTING THE GRASS-CATCHER
First of all assemble the frame, joining the upper part
(1), including the opening, to the lower part (2), using
the supplied nuts and screws (3) and following the
indicated sequence.
Position the angle supports (4) and (5), respecting the right (R ) and left (L ) sides,
and attach them to the frame using the four self-tapping screws (6).
All manuals and user guides at all-guides.com
To prevent the safety device
Follow the battery manu-
To avoid damaging the steering wheel with the hammer, use an
UNPACKING AND ASSEMBLY
7
5
6
2
3
3
9
8
2
3
1
1
Publicité
