Publicité
All manuals and user guides at all-guides.com
CYLINDER HEAD AND CYLINDER
SDN5320
a
SDN5330
SDN5340
SDN5350
5. Check:
•
Piston ring position
CAUTION:
•
Make sure that the ring ends are properly fitted
around the ring locating pins in the piston
grooves.
•
Be sure to check that the manufacturer's marks
or numbers stamped on the rings face upward.
6. Install:
•
Gasket (cylinder)
NOTE:
•
Install the gasket so that the side with eleva-
tions faces upward.
•
The edge with the notch a should be between
cylinders #1 and #2.
7. Install:
•
Cylinder
NOTE:
Install the cylinder with one hand while com-
pressing the piston rings with the other hand.
8. Tighten:
•
Nuts (cylinder head)
Tightening steps:
•
Temporarily tighten the cylinder head nuts 1
~ 6 as follows.
1st step:
•
Tighten the nuts 1 ~ 6
Nut (cylinder head) 1 ~ 6:
13 Nm (1.3 m • kg, 9.4 ft • lb)
2nd step:
•
Retighten the nuts 1 ~ 6
Nut (cylinder head) 1 ~ 6:
28 Nm (2.8 m • kg, 20 ft • lb)
5-16
ENG
Publicité
