Stryker MX-PRO R3 Mode D'emploi page 7

• Always use two operators when a cot is occupied.
• Always follow proper hand placement on hand grips. Keep all hands clear of the red safety bar pivots when you load or
unload the cot or change cot height position.
• Do not pull or lift on the cot safety bar when you unload the cot.
• Always lock the undercarriage before you remove the loading wheels from the vehicle patient compartment floor. An
unlocked undercarriage will not support the cot and injury to the patient or operator could result.
• Do not allow the cot undercarriage to drop unassisted (commonly known as a hot drop) when you remove the cot from
the vehicle. Repeated hot dropping causes premature wear or damage to the cot.
• Always keep hands, fingers, and feet away from moving parts. Use caution when placing your hands and feet near the
base tubes while you raise or lower the cot.
• Always keep hands away from the foot end release handle when you raise or lower the cot with the side release handle.
• Always remove your foot from the base tube when you lower the cot to the lowest position.
• Do not use siderails as a patient restraint device.
• Do not operate the cot with the breakaway head section lowered to avoid injury to the patient or operator or damage to
the cot. Use only positions 5-7 with this configuration.
• Always secure the defibrillator platform to the product when you use the defibrillator platform.
• Always use and adjust the straps that are provided with the defibrillator platform to secure the defibrillator.
• Always use any appropriate personal protective equipment while power washing to avoid inhaling contagion. Power
washing equipment may aerate contamination.
• Always clean or dispose of contaminated mattress or cot components to avoid the risk of exposure to blood borne
pathogens and injury to the patient or the operator.
C C A A U U T T I I O O N N
• Improper usage of the product can cause injury to the patient or operator. Operate the product only as described in this
manual.
• Do not modify the product or any components of the product. Modifying the product can cause unpredictable operation
resulting in injury to patient or operator. Modifying the product also voids its warranty.
• Always set the cot load height before you place the cot into service.
• Do not lower the cot in the shortened position to avoid damage to the cot. Use only positions 5-7 when you shorten the
cot.
• Always change the attachment location or adjust the straps for your specific defibrillator size or shape.
• Do not load the defibrillator platform above the safe working load of 75 lb (34 kg).
• Do not load the IV pole above the safe working load of 40 lb (18.1 kg).
• Do not steam clean or ultrasonically clean the product.
• Do not exceed 180 °F (82 °C) as the maximum water temperature.
• Do not exceed 240° F (115° C) as the maximum air dry temperature (cart washers).
• Do not exceed 1500 psi (103.4 bar) as the maximum water pressure. If you use a hand held wand to wash the product,
keep the pressure nozzle at a minimum of 24 in. (61 cm) from the product.
• Always towel dry all casters and interface points.
• Do not clean, service, or perform maintenance while the product is in use.
6082-209-005 Rev AA.2 3 EN