Stryker MX-PRO R3 Mode D'emploi page 21

O O p p e e r r a a t t i i o o n n
O O p p e e r r a a t t i i n n g g g g u u i i d d e e l l i i n n e e s s
• Use the product only as described in this manual.
• Read all labels and instructions on the product before use.
• Always load or unload an occupied cot with a minimum of two trained operators. Two operators must be present when a
cot is occupied. Stryker recommends that both operators are at the foot end to reduce the load on each operator. One or
two operators can lift from the foot end of the cot.
• Do not adjust, roll, or load the cot into a vehicle without advising the patient. Stay with the patient and control the product
at all times.
• Only use the wheel locks during patient transfer or without a patient on the product.
• Do not apply a wheel lock when an patient is on the product or when you move the product to avoid the risk of tipping.
• Always use all restraint straps and keep the siderails up when a patient is on the product.
• Use trained helpers to control the product, when necessary.
T T r r a a n n s s f f e e r r r r i i n n g g t t h h e e p p a a t t i i e e n n t t t t o o t t h h e e c c o o t t
W W A A R R N N I I N N G G
• Always use all restraint straps to secure the patient on the product. An unrestrained patient may fall from the product and
be injured.
• Do not apply a wheel lock when a patient is on the product or when you move the product to avoid the risk of tipping.
To transfer the patient to the product:
1. Roll the product to the patient.
2. Place the product beside the patient and raise or lower the product to the level of the patient.
3. Lower the siderails and open the restraint straps.
4. Transfer the patient to the product. Follow accepted EMS procedures.
5. Secure the patient to the product with all of the restraint straps.
6. Raise the siderails and adjust the backrest and footrest as necessary.
R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e c c o o t t
1. Both users must lift the weight off of the base.
2. The user at the foot end must pull the release handle.
3. Both users must lower the cot to the ground or raise the cot up.
A A p p p p l l y y i i n n g g o o r r r r e e l l e e a a s s i i n n g g a a w w h h e e e e l l l l o o c c k k
W W A A R R N N I I N N G G
• Do not apply a wheel lock when a patient is on the product or when you move the product to avoid the risk of tipping.
• Do not install or apply a wheel lock on a product with worn wheels that are less than 6 in. diameter.
• Do not leave a patient or occupant unattended. Hold the product while a patient or occupant is on the product.
To apply a wheel lock, press down on the pedal until it stops and is resting against the surface of the wheel.
6082-209-005 Rev AA.2 17 EN