Stryker MX-PRO R3 Mode D'emploi page 29

R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e c c o o t t w w i i t t h h o o n n e e o o p p e e r r a a t t o o r r
You can raise or lower an unoccupied cot into a vehicle with one operator.
W W A A R R N N I I N N G G
• Always keep hands, fingers, and feet away from moving parts. Use caution when placing your hands and feet near the
base tubes while you raise or lower the cot.
• Always follow proper hand placement on hand grips. Keep all hands clear of the red safety bar pivots when you load or
unload the cot or change cot height position.
• Always remove your foot from the base tube when you lower the cot to the lowest position.
• Always keep hands away from the foot end release handle when you raise or lower the cot with the side release handle.
To raise or lower the cot:
From the foot end
1. Grasp the lower foot end lift tube.
2. Tip the cot up on its load wheels.
3. Squeeze and hold the release handle and raise or lower
the cot.
4. Release the release handle when you reach the desired
height.
5. Lower the cot back on onto the four base wheels.
R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e f f o o o o t t r r e e s s t t
You can adjust the footrest to elevate the patient's legs.
To raise the footrest, lift the frame as high as possible. The support bracket automatically secures the frame when you
release the footrest.
To lower the footrest, lift the frame and lift up on the footrest release handle until the frame releases the support bracket.
Lower the footrest until it lays flat.
R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e b b a a c c k k r r e e s s t t
To raise the backrest, squeeze the backrest adjustment handle to move the backrest to the desired height.
To lower the backrest, squeeze the backrest adjustment handle while you push down on the backrest to the desired height.
R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e s s i i d d e e r r a a i i l l s s
Always lower the siderails when you transfer a patient to the cot or from the cot.
W W A A R R N N I I N N G G - - Do not use siderails as a patient restraint device.
To raise the siderails, lift up on the siderail until the latch clicks and the siderail locks into place. Always keep the siderails in
the raised position unless you are transferring the patient.
To lower the siderails, squeeze the siderail release handle to release the siderail latch. Guide the siderail down toward the
foot end of the cot until the siderail lays flat. Always lower the siderails when you transfer a patient to or from the cot.
6082-209-005 Rev AA.2
From the side
1. Place one foot on the outer base tube.
2. Grasp the side release handle with one hand. Place
your other hand on the outer support rail to stabilize the
cot.
3. Squeeze and hold the release handle and raise or lower
the cot.
4. Release the release handle when you reach the desired
height.
25 EN