SICE S 42 Manuel D'instructions page 27

Les langues disponibles

ENGLISH • Instructions manual

screws (18, Fig. B7) already fitted on the post.

PNEUMATIC HOOK UP

For correct pneumatic hook-up, proceed as follows:

1) Lower the pedal (5, Fig. G) all the way down to avoid sudden opening of

the clamps.

2) Connect the machine to a compressed air supply (with recommended operat-

ing pressure of 8 - 10 bar) by means of the coupling (19, Fig. C1) supplied as

standard, using a 7 – 8 mm (internal Ø) rubber hose for compressed air.

WARNING!

The compressed air pressure must not exceed 16 Bar.

3) A connection (20, Fig. C2) for an inflation air gun is provided on the rear.

WARNING!

Use the union (20, Fig. C2) only for the outlet of air (to

connect inflating device).

Do not connect the compressed air network to this

union: you could break the pneumatic equipment and

the safety devices.

ELECTRIC HOOK UP

Before making any electric hook up, check to be certain that the mains

voltage corresponds to what is stamped on the voltage tag (attached on the

feeding cable of the tyre changer).

It is absolutely essential that the system is equipped with a good ground-

ing circuit.

The machine must be connected to a power supply line circuit breaker set

for 30mA.

Note the required power draw as highlighted on the tag-plate fixed to the

back of the tyre changer.

Check to make sure the shop electric wiring circuit is dimensioned suf-

ficiently to carry this.

WARNING!

Work on the electric system, even if minor, must be done

exclusively by professionally qualified personnel.

Manufacturer shall not be liable for any injury to persons

or damage to things caused by failure to comply with

these regulations and can cancel warranty coverage.

FITTING THE BEAD BREAKER ARM

1) Fit the washer (21, Fig. D1) on the bead breaker arm support (see Fig.

D1).

All manuals and user guides at all-guides.com

S 42