MINN KOTA RIPTIDE POWERDRIVE Instructions D'installation page 9

7
ITEM(S) NEEDED
#4 x 6
k. Put a 1/4-20 x 3-1/2" (Item #1) Mounting Bolt in
each of the drilled locations. The Mounting Bolt
should pass through the Base Extrusion and the
boat deck. If the Rubber Washers (Item #4) are
used, they should sit between the Base Extrusion
and boat deck. Make sure to secure the motor with
screws on each side of the Base Extrusion.
8
ITEM(S) NEEDED
#2 x 6
l. Place a Flat Washer (Item #2) and then a Nylock Nut
(Item #3) at the end of each Mounting Bolt as shown
and secure. Make sure all hardware is secure.
NOTICE: To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
©2023 Johnson Outdoors Marine Electronics, Inc.
#1 x 6
#3 x 6
INSTALLING THE RIPTIDE POWERDRIVE
Mounting Bolt
Rubber Washer Rubber Washer
Mounting Bolt
Rubber Washer Rubber Washer
Boat Deck Boat Deck
Boat Deck Boat Deck
Flat Washer
Nylock Nut
minnkotamotors.com | 9