MINN KOTA RIPTIDE POWERDRIVE Instructions D'installation page 16

ADVANCED GPS NAVIGATION
3
NOTICE: Minn Kota recommends routing the
Ethernet Cable through the Coil Cord when
making the Ethernet connection. The cable will
be installed from the Mount to the Control Head
through the Coil Cord and parallel to the Advanced
GPS Cable. Bypassing the Coil Cord when routing
the Ethernet Cable is not recommended.
e. To install the Ethernet Cable, align the pins on
the Advanced GPS Ethernet Connector with the
Receptacle on the Ethernet Cable. Notice the keyed
connectors. Press the ends together and tighten the
Collar from the Ethernet Cable to secure
the connection.
f. The Ethernet Cable will plug directly into a Solix
or Apex Fish Finder or directly into a Helix
Adapter Cable.
4
If installing directly to a Solix or Apex, the
g.
connector will be flat on the back of the fish
finder display.
h. Align the Receptacle on the Ethernet Cable with the
Eight Pin Connector on the Apex or Solix fish finder.
Notice the keyed connectors. Tighten the Collar
from the Ethernet Cable to secure the connection.
Once directly installed to the Solix or Apex, the
connection is complete.
16 | minnkotamotors.com
3e
Control Control
Head Head
Advanced Advanced
GPS GPS
Ethernet Ethernet
Connector Connector
Mount Mount
3e
Eight Pin Eight Pin
Connector Connector
Advanced GPS Advanced GPS
Ethernet Connector Ethernet Connector
from Trolling Motor from Trolling Motor
Ethernet Ethernet
Cable Cable
Receptacle Receptacle
Ethernet Cable Ethernet Cable
Ethernet Cable Ethernet Cable
Foot Pedal Foot Pedal
Power
Power Connector Power Connector
Leads
Receptacle Receptacle
Ethernet Ethernet
Cable Cable
Receptacle Receptacle
Eight Pin Eight Pin
Connector on Connector on
Solix or Apex Solix or Apex
Fish Finder Fish Finder
©2023 Johnson Outdoors Marine Electronics, Inc.