MINN KOTA RIPTIDE POWERDRIVE Instructions D'installation page 19

2
ITEM(S) NEEDED
c. Check the Accessory Cables and confirm that the
cables that are connected run parallel down the
center of the Coil Cord.
d. While the motor is in the stowed position,
straighten the Accessory Cables so they run
neatly from the Control Head to the Mount.
e. Starting approximately 4 inches below the
Control Head, take a Cable Tie (Item #16) and
place it around the Accessory Cables inside the
Coil Cord.
NOTICE:
Do NOT secure the Accessory Cables
to the Coil Cord. ONLY secure the Accessory
Cables with the Cable Ties to the other
Accessory Cables.
f. Secure the Cable Tie around the Accessory
Cables until it is fingertip tight. Do not over-
tighten the Cable Tie as it will cause damage to
the Accessory Cables.
3
g. Follow the Accessory Cables from the Control
Head to the Mount and place additional Cable
Ties every 4 inches around the Accessory Cables
after the first Cable Tie. The number of Cable Ties
needed will vary depending on the length of your
trolling motor Shaft.
NOTICE: If additional Cable Ties are needed, a
Service Assembly (#2996300 TIE WRAP ASM,
60") is available from the Parts Ordering Portal
at minnkotamotors.com.
©2023 Johnson Outdoors Marine Electronics, Inc.
#16 x 1
SECURING ACCESSORY CABLES
Control Control
Head Head
Advanced Advanced
GPS Cable GPS Cable
Approximately Approximately
4 inches 4 inches
CAUTION
Do not over-tighten the Cable Ties as it may damage the wires.
Shaft Shaft
Control Control
Head Head
Approximately Approximately
4 inches 4 inches
Approximately Approximately
4 inches 4 inches
Approximately Approximately
4 inches 4 inches
Mount Mount
GPS Ethernet GPS Ethernet
Connection Connection
Ethernet Ethernet
Cable or Cable or
Ethernet Extension Ethernet Extension
Cable Cable
Cable Tie Cable Tie
First First
Cable Tie Cable Tie
Cable Tie Cable Tie
Cable Tie Cable Tie
Cable Tie Cable Tie
minnkotamotors.com | 19