MINN KOTA RIPTIDE POWERDRIVE Instructions D'installation page 14

ADVANCED GPS NAVIGATION
GPS Ethernet Connection
Control Head Control Head
Advanced GPS Advanced GPS
Ethernet Ethernet
Connector Connector
Advanced Advanced
GPS Cable GPS Cable
Coil Cord Coil Cord
Mount Mount
Failure to follow the recommended wire routing for installed features, if equipped, may cause damage to the product and void your
product warranty. Route cables away from pinch points or other areas that may cause them to bend in sharp angles. Routing the cables
in any way other than directed may cause damage to the cables by being pinched or severed. Do not over-tighten cable ties as it may
damage the wires.
1
NOTICE: Your fish finder should be turned off
until this procedure is complete.
a. Place the motor in the deployed position.
b. Locate the Eight Pin Advanced GPS Ethernet
Connector below the Control Head. The Advanced
GPS Ethernet Connector will exit the base of the
Control Head and will rest just below the Control
Head next to the Coil Cord.
14 | minnkotamotors.com
Ethernet Cable Ethernet Cable
Advanced Advanced
GPS Cable GPS Cable
Foot Pedal Foot Pedal
Power Connector Power Connector
Power Leads
CAUTION
(provided) (provided)
Control Head Control Head
Advanced Advanced
GPS Ethernet GPS Ethernet
Connector Connector
Eight Pin Eight Pin
Advanced Advanced
GPS Ethernet GPS Ethernet
Connector Connector
Advanced Advanced
GPS Cable GPS Cable
Mount Mount
To Helix
Helix Adapter Helix Adapter
Cable (if needed) Cable (if needed)
Directly
to Solix
or Apex
Foot Pedal Foot Pedal
Power Power
Connector Connector
Advanced Advanced
GPS Cable GPS Cable
Power Leads
©2023 Johnson Outdoors Marine Electronics, Inc.