MINN KOTA RIPTIDE POWERDRIVE Instructions D'installation page 12

IDENTIFYING TROLLING MOTOR FEATURES AND THEIR ASSOCIATED CABLES
3
e. Holding the end of the Armature Shaft with a Flat
Blade Screwdriver, tighten the Prop Nut with a 9/16"
Open End Wrench.
f. Tighten the Prop Nut 1/4 turn past snug to
25-35 in-lbs.
CAUTION
Do not over tighten as this can damage the prop.
IDENTIFYING TROLLING MOTOR FEATURES AND THEIR ASSOCIATED CABLES
Feature & Cable Identification
The Riptide PowerDrive is pre-installed with Advanced GPS
Navigation - including the ability to connect via Ethernet to a
Humminbird fish finder. To get the full benefit of this feature, it is
necessary to connect the Accessory Cables to an output device.
The connectors are present on the trolling motor and have cables
that exit below the Control Head or exit the Coil Cord at the base of
the Mount. To better identify cables present, refer to the diagrams
that detail what the Advanced GPS Navigation connectors look like.
Identifying Connectors
TWO connectors are present below the Control Head for Riptide
PowerDrive trolling motors equipped with:
Advanced GPS Navigation - When Advanced GPS Navigation is
pre-installed on your trolling motor, one eight pin Advanced GPS
Ethernet Connector will exit the base of the Control Head and
rest just below the Control Head next to the Coil Cord and one
Advanced GPS Cable will exit the base of the Control Head and
run down the center of the Coil Cord. The Advanced GPS Cable
will come to a "Y" near the Mount of the trolling motor. One half
of the "Y" will enter the Mount next to the Power Leads and the
main portion of the cable will be attached from the factory to
the Foot Pedal Power Connector. If a trolling motor is equipped
with Advanced GPS Navigation, it will not be equipped with
a Foot Pedal. If the Advanced GPS Navigation on the trolling
motor will be used with a fish finder, an Ethernet Cable may be
attached to the Advanced GPS Ethernet Connector below the
Control Head. See the "Advanced GPS Navigation" section of
this document for details on how to install the Advanced GPS
Ethernet Connector to a Humminbird.
12 | minnkotamotors.com
Prop Washer Prop Washer
Prop Nut Prop Nut
Propeller Propeller
Advanced GPS Navigation
Threaded Collar Threaded Collar
Ethernet Cable Ethernet Cable
from Trolling Motor from Trolling Motor
TWO Connectors
Control Head Control Head
Advanced Advanced
Ethernet Ethernet
Connector Connector
Advanced Advanced
GPS Cable GPS Cable
Mount Mount
Drive Pin Drive Pin
Eight Pin Connector Eight Pin Connector
GPS GPS
Eight Pin Eight Pin
Connector Connector
Coil Cord Coil Cord
Foot Pedal Foot Pedal
Advanced Advanced
GPS Cable GPS Cable
Connector Connector
Power Leads
©2023 Johnson Outdoors Marine Electronics, Inc.
Power Power