MINN KOTA RIPTIDE POWERDRIVE Instructions D'installation page 15

2
ITEM(S) NEEDED
c. Take the Ethernet Cable (Item #14) and identify the
Receptacle on either end. It will be keyed to fit with
the Eight Pin Advanced GPS Ethernet Connector
below the Control Head.
NOTICE: The Ethernet Cable has a Receptacle
for the Advanced GPS Ethernet Connector on both
ends and either end may be connected.
d. Leading with either Receptacle, take the cable and
fish it through the center of the Coil Cord starting at
the end of the Coil Cord attached to the Mount and
working up towards the Control Head. The cable
will run parallel to the Advanced GPS Cable. Allow
enough slack in the cable to attach the Receptacle
to the Advanced GPS Ethernet Connector.
NOTICE: The 30' Ethernet Cable
30' Ethernet Cable -
an alternate length is preferred, alternate cable
lengths are available from humminbird.com.
NOTICE: The 30' Ethernet Extension Cable
(AS ECX 30E - 30' Ethernet Extension Cable -
760025-1) is available from
and should be used if the standard 30' Ethernet
Cable provided with your trolling motor is not long
enough to reach the fish finder.
©2023 Johnson Outdoors Marine Electronics, Inc.
#14 x 1
(AS EC 30E -
720073-4) is provided. If
humminbird.com
ADVANCED GPS NAVIGATION
2c
Eight Pin Eight Pin
Connector Connector
Advanced GPS Advanced GPS
Ethernet Connector Ethernet Connector
from Trolling Motor from Trolling Motor
Control Control
2d
Head Head
Advanced GPS Advanced GPS
Ethernet Ethernet
Connector Connector
Advanced Advanced
GPS Ethernet GPS Ethernet
Advanced Advanced
Connector Connector
GPS Cable GPS Cable
Mount Mount
Power Connector Power Connector
Receptacle Receptacle
Ethernet Ethernet
Cable Cable
Ethernet Cable Ethernet Cable
Advanced Advanced
GPS Cable GPS Cable
Foot Pedal Foot Pedal
Power Leads
minnkotamotors.com | 15