MINN KOTA RIPTIDE POWERDRIVE Instructions D'installation page 11

Installing the Prop
1
CAUTION
Disconnect the motor from the battery before
beginning any prop work or maintenance.
a. While holding the Shipping Spacer with a pliers
or vise grip, remove the Prop Nut, Red Shipping
Washer, Prop Washer and Spacer, being careful
not to lose the Drive Pin. Reuse the Prop Nut, Prop
Washer and Drive Pin to attach the Propeller.
NOTICE: The Shipping Spacer and Red Shipping
Washer are for shipping purposes only and must
be discarded. The Red Shipping Washer will rust if
used to attach the Propeller.
2
ITEM(S) NEEDED
#5 x 1
b. Take the Drive Pin (Item #8) and slide it through
the Hole in the Armature Shaft. Position the Drive
Pin horizontal by grasping the Armature Shaft and
rotating it with the Drive Pin in place.
c. Align the Propeller (Item #5) so it is also horizontal
and parallel with the Drive Pin. Slide the Propeller
onto the Armature Shaft and Drive Pin until it is
seated against the lower unit.
d. Install the Prop Washer (Item #6) and the Prop Nut
(Item #7) onto the end of the Armature Shaft.
©2023 Johnson Outdoors Marine Electronics, Inc.
#6 x 1 #7 x 1
Prop Prop
Washer Washer
Drive Drive
Prop Prop Pin Pin
Nut Nut
Shipping Shipping
Spacer Spacer
(discard) (discard)
Red Red
Shipping Shipping
Washer Washer
(discard) (discard)
#8 x 1
2b
Drive Pin Drive Pin
Prop Washer Prop Washer
2c
INSTALLING THE PROP
Armature Armature
Shaft Shaft
Prop Nut Prop Nut
Propeller Propeller
minnkotamotors.com | 11
Propeller Propeller