MINN KOTA RIPTIDE POWERDRIVE Instructions D'installation page 20

SECURING ACCESSORY CABLES
4
h. Continue placing Cable Ties around the
Accessory Cables until the cables exit the Coil
Cord next to the Mount, when the Motor is in the
stowed position. The Cable Ties should be placed
approximately every 4 inches.
i. After the Accessory Cables exit the Coil Cord
continue to secure the Accessory Cables every 4
inches until there are two Cable Ties in place on
the Accessory Cables after the Coil Cord.
NOTICE: Secure the Cable Ties fingertip tight.
It is recommended to have them ONLY tight
enough so that they do not slide around on the
Accessory Cables and hold the cables together.
20 | minnkotamotors.com
Coil Cord Coil Cord
Cable Tie Cable Tie
Approximately Approximately
4 inches 4 inches
Cable Tie Cable Tie
Approximately Approximately
4 inches 4 inches
Cable Tie Cable Tie
Approximately Approximately
4 inches 4 inches
Cable Tie Cable Tie
Approximately Approximately
4 inches 4 inches
Cable Tie Cable Tie
©2023 Johnson Outdoors Marine Electronics, Inc.
Control Control
Head Head
Mount Mount