MINN KOTA RIPTIDE POWERDRIVE Instructions D'installation page 10

INSTALLING THE RIPTIDE POWERDRIVE
9
m. Replace the Right Sideplate.
n. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
9m
10
o. Replace the four Sideplate Screws using a #3 or
#2 Phillips screwdriver. Two of these screws will be
located on each side of the mount.
10 | minnkotamotors.com
Right Sideplate Right Sideplate
9n
Base Extrusion Base Extrusion
Left Left
Sideplate Sideplate
Sideplate Screw Sideplate Screw
©2023 Johnson Outdoors Marine Electronics, Inc.