Publicité
Les langues disponibles
Les langues disponibles
Operation
Drain distillate
End of process
➜
Confirm or discard all changes with
Process parameters
Process parameters
➜
Tap the
–
The process parameters menu opens.
➜
Touch the function button of the desired parameter and adjust the value using the screen
keyboard, see also „User input" on page 99.
Parameters
Heating tape
Heating tape
automatic
Evacuation after
draining the
collector
Educt empty:
additional
evaporation time
Forced draining
of the collector
Standby timer
after educt
container runs
empty
➜
➜
➜
Distillate draining time
• In the selection field, define a distillate draining time
(adjustment via plus/minus buttons or tap/on-screen
keyboard).
Specify here whether the distillate and/or residue are drained
at the end of the process. Touch the corresponding checkbox to
activate (checkmark) or deactivate the selection.
Accept
button in the footer.
Function
Performance of the heating tape during operation.
Range: 10 – 100% in increments of ten.
(see „Heating tape (optional)" on page 92)
Automatically switch on heating tape yes/no.
Range: on / off.
Evacuation period of the bypass line after draining the collector
vessel.
Range: 1 – 9999 s.
When the educt container runs empty: Additional evaporation
time for evaporation of the remaining educt in the evaporation
flask.
Range: 1 – 9999 s.
Forced draining of the collector active: Collector will be drained
after 1 – 9999 seconds, regardless of the filling level.
Range: 1 – 9999 s.
Activate/deactivate forced draining of the collector (determines
previous parameter!).
Range: active / inactive
Time until the standby mode is activated after the educt
container runs empty.
Range: 1 – 9999 s.
Hei-VAP parameters
page 127.
Data logging
, see section „Data recording" on page 113.
Save
, see section „Recipes" on page 128.
Cancel
or
.
, see section „Parameters Hei-VAP" on
134
Publicité
