Heidolph Hei-VOLUME Distimatic Pro Notice D'instructions page 100

Commissioning
Commissioning
Commissioning
Observe the following steps when commissioning the automatic Hei-VOLUME Distimatic Pro
module.
Switch the device on/off
To switch on and off the automatic module, use the main switch on the front of the
Distimatic Pro (see section „Control elements" on page 88).
CAUTION
If the Distimatic Pro is switched on and off incorrectly, there is a risk
that peripheral devices will not be detected correctly or will switch in an
uncontrolled manner!
Observe the order given when switching the Distimatic Pro and the
connected peripheral devices on and off.
In particular, before turning off the Distimatic Pro, make sure that all
processes have been completed properly.
Observe the following sequence when turning the automatic module and
attached peripherals on and off:
➜
➜
TURNING ON THE SYSTEM: First, turn on all peripheral
devices so that they are recognized when initializing the automatic
module software.
TURNING OFF THE SYSTEM: First, turn off all peripherals to
put the entire system in a safe operating condition.
100