Commissioning
Automatic drainage of residue
Formats
In the
menu, you can define whether the residue is automatically drained from the
evaporation flask (blowing out in overpressure operation), or whether the flask is drained by
hand.
with automatic drainage of residue
A system
operated automatically in continuous operation (condition: continuous supply with educt!).
Operation with automatic drainage of residue
with automatic drainage of residue
In operation
drained under the following conditions:
–
Stagnation reached in sensor mode.
–
Distillate drain counter expired in sensor mode.
–
Refill counter expired in sensor mode.
–
Additional evaporation time for distillate drain or refill counter has expired in sensor
mode.
–
Number of defined steps (filling/evaporation) reached in time mode.
Operation without automatic drainage of residue
without automatic drainage of residue
In operation
must be drained by hand.
Drainage of residue selection
➜
The active selection is highlighted in orange when the
To change, touch the desired function button
Residue Extraction
➜
Confirm the new setting with
mation prompt!
discard
➜
Touch the
Select evaporator type/glassware
Formats
In the
menu, you can define the connected evaporator type including the glassware
used. The selection stored in the system appears in the form of function buttons:
➜
The active selection (in the example: Hei-VAP Industrial with set of glassware R) is highl-
ighted in orange. Touch the desired function button to switch between options.
➜
Confirm the new setting with
mation prompt!
discard
➜
Touch the
The selection evaporator type/glassware is necessary for display
purposes only!
.
ok
. The change is accepted immediately without a confir-
button to discard the change.
ok
. The change is accepted immediately without a confir-
button to discard the change.
112
, in sensor or time mode can be
, the residue is automatically
, the evaporation flask
Formats
menu is opened.
with / without automatic.