Publicité
Les langues disponibles
Les langues disponibles
Operation
Process parameters
Process parameters
➜
Touch the
➜
Tap the button of the desired parameter in the menu and adjust the value using the
on-screen keyboard, see also „User input" on page 99.
Parameters
Heating tape
Heating tape
automatic
Evacuation after
draining the
collector
Warm-up time,
filling in
sensor mode
Educt empty:
additional
evaporation time
Max. filling:
additional
evaporation time
button in the footer to open the menu.
Function
On-period of the heating tape in operation.
Range: 10 – 100% in increments of ten.
(see „Heating tape (optional)" on page 92)
Automatically switch on heating tape yes/no.
Range: on / off.
Evacuation period of the bypass line after draining the collector
vessel.
Range: 1 – 9999 s.
Warm-up time when filling the evaporation flask in sensor mode.
Range: 1 – 9999 s.
When the educt container runs empty: Additional evaporation
time for evaporation of the remaining educt in the evaporation
flask.
Range: 1 – 9999 s.
Maximum filling rate: Selectable when a specific number of
filling operations is specified in the start window:
In the example: five fillings, then optionally an additional
evaporation time runs. This allows a desired concentration to be
achieved!
max. filling: Add. evaporation
The parameters
time
max. drain distillate: additional
and
evaporation time
activated at the same time!
126
are mutually exclusive and cannot be
Publicité
