Webasto Next Notice De Montage page 21

2 General information
For the latest version of this document, see: https://
charging.webasto.com/int/products/documentation
2.1 Purpose of the document
This Quick Start Guide is part of the product and contains
introductory information about the product Webasto
Next and information relating to safety and installation.
The updated version of the is available here:
https://charging.webasto.com/int/products/
documentation
The comprehensive Operating and Installation Instruc-
tions are necessary for safe installation and operation of
your Webasto Next.
The Operating- and Installation Instructions are necessary
for using:
– the WebUI
– the Dynamic Load Management (DLM)
– the Home Energy Management System (HEMS)
You can find our Operating and Installation Instructions
on the Webasto website at:
https://charging.webasto.com/int/products/
documentation
Using this document
2.2
u Carefully read this Quick Start Guide prior to installing
and starting up the Webasto Next.
u Keep these instructions ready to hand.
u Hand this document on to the following owner or
user of the charging station.
NOTE
We would draw your attention to the fact that, as
part of a professional installation, an installation log
should be drawn up by the installer. We also request
that you fill in our chapter 9, "Checklist for the install-
ation of the Webasto charging station" on page 29.
NOTE
Individuals with deficiency in their colour vision re-
quire support in the allocation of all fault indicators.
5111233C_ISI_Next
Intended use
2.3
The Webasto Next charging station is designed for char-
ging electric vehicles in accordance with IEC 61851-1,
charge mode 3.
2.4 Use of symbols and highlighting
DANGER
This signal word denotes a hazard with a high degree
of risk which, if not avoided, may lead to death or ser-
ious injury.
WARNING
This signal word denotes a hazard with a moderate
degree of risk which, if not avoided, may lead to
minor or moderate injury.
CAUTION
This signal word denotes a hazard with a low degree
of risk which, if not avoided, will lead to minor or
moderate injury.
NOTE
This signal word denotes a Special Technical Feature
or (if not observed) potential damage to the product.
Refers to separate documents which are enclosed or
can be requested from Webasto.
2.5 Warranty and liability
Webasto shall not assume liability for defects or damage
that are the result of the installation and operating in-
structions being disregarded. This liability exclusion par-
ticularly applies for:
– Improper use.
– Repairs carried out by an electrician not contracted by
Webasto.
– Use of non-original spare parts.
– Unauthorised conversion of the unit without permis-
sion from Webasto.
– Installation and commissioning by unqualified staff
(not an electrician).
– Improper disposal after decommissioning.
WARNING
Installation and connection of the charging station
must only be carried out by a qualified electrician.
The symbol of a bin with a line through it means
that the instructions in the chapter on Disposal
must be followed.
2.6 Software licences
This product contains open-source software. Further in-
formation relating to this (disclaimer, written offers, li-
cence information) can be found via the integrated web
server. The web server can be reached via the hotspot
(https://172.0.2.1/licensing.html).
Safety
3
3.1 General information
The device must only be used in a technically faultless
condition.
Any malfunctions that adversely affect the safety of per-
sons or of the device must be immediately rectified by a
qualified electrician in accordance with nationally applic-
able regulations.
General safety information
3.2
– Hazardous voltages are present within the casing.
– The charging station does not have its own main
ON/OFF switch. The protective devices installed in
the power supply system are therefore also used
to disconnect the power supply.
– Check charging station for visual damage before
use. Do not use the charging station if damaged.
– Installation, electrical connection and initial opera-
tion of the charging station must only be carried
out by an electrician.
– Do not remove the cover of the installation area
whilst in operation.
– Do not remove markings, warning symbols and
the type label from the charging station.
– The charging cable must only be replaced by an
electrician in accordance with the installation in-
structions.
EN
21