MR TAPCON 250 Instructions D'installation page 58

6 Mounting
2. Slide the device into the cutout from the front and secure using the recom-
mended screws.
Figure 42: Inserting and screwing in the device
ð The device is mounted and can be wired up.
6.3.2 Fastening the cap rail
The cap rail is required to mount a bus bar or a device's remote assemblies
in a control cabinet. Only use the following types of cap rails in accordance
with EN 60715:
▪ TH 35-7.5
▪ TH 35-15
The cap rail may not be painted or lacquered.
®
58 TAPCON 250 8741483/02 EN Maschinenfabrik Reinhausen GmbH 2022