Glass Cleaning - Rizzoli M Série Manuel D'utilisation

4.9

GLASS CLEANING

The glasses of the fire door and of the combus-
tion chamber can be cleaned with normal specific
products you can find in commerce. The internal
part of the combustion chamber door is designed
WARNING! Do not clean the glass before waiting for its cooling. Suddenly changes in
temperature may cause breakings in the glass.
4.10 PLATE CLEANING AND MAINTENANCE
Radiating plates in special steel need regular main-
tenance, in particular they need cleaning after
every use that brings moisture or dust on the plate
itself.
With cold cooker you have to remove all the pots
and boilers that could maintain moisture on the
plate.
Together with the device are given some exclusive
products, studied for the cleaning and the mainte-
nance of the plate: the abrasive sponge, the plate
cleaner and the oil for plate care. On how to use
them please read the instructions written on the
bottles.
The plates are all worked in with non acid anti­cor-
rosion oil. The use of the cooker deletes this oil lay-
er and so the contact with water may cause small
rusty stains. In this case you have to wipe the plate
with a rag with the plate cleaner given togeth-
er with the device. If the rusty stain is not being
cleaned, you could have to wipe the plate with the
abrasive sponge or with a lightly abrasive paper.
4.11 MAINTENANCE OF THE LIGHT
WARNING! Before starting any maintenance operation for the light, you must discon-
nect it from AC power and be sure that the cooker is not powered. Verify also if the
cooker is cold and if the light was turned on in the previous minutes.
Oven lamp suffers high temperatures. Even if it
is designed to work in these conditions, it could
become out of order. You have to replace it with
a lamp with the same features (halogen lamp 25W
230V 300° connection G9). To replace the lamp
you have to unscrew the lamp cover, remove the
to clean itself during the use of the cooker. Any-
way, sometimes you could have the need to clean
also the internal part.
To restore the protecting layer wipe the plate with
little oil for plate care.
In any case, cleaning with water must be avoided.
It is important to be sure that the expansion cuts
and the hole between the plate and the frame are
not obstructed by dust or by other residuals: the
plate could suffer deformations, also permanent.
When it is necessary, you should clean also the
beating of the circled removing eventual residu-
als. Radiating steel plates, exposed to continuous
heating, trend slowly to take a burnished colour;
if you want to accelerate the process, repeat fre-
quently the wiping with oil for plate care.
When the cooker has not been used for a long
time it is suggested to treat the plate with the oil
for plate care, in this way the plate is protected
against moisture in the best way.
To remove the plate, you have to lift it up. When
you reinsert the plate, keep in mind to leave the 1
or 2 millimetres to allow the thermal expansion of
the plate itself.
lamp, insert the new lamp and finally screw in the
lamp cover. Seldom, it is necessary to clean the
glass of the lamp cover. To make this, you have to
unscrew the lamp cover, remove the external re-
siduals due to the cooking steams, wash the lamp
cover and once it is dry you can screw it in its place.
90