Figure 2-13 Clear Feed Interval; Figure 2-14 Connect Disposable Set To Feeding Tube; Figure 2-15 Pump Is Running; Figure 2-16 Amount Currently Delivered - Moog infinity Manuel De L'opérateur

NOTE: For a single feeding the feed interval
setting should be programmed to NONE (Figure
2-13). When you have finished setting rate and
dose check the display to see if it reads FEED
INTERVAL. If it does, press the
CLEAR
press the key. Display will read NONE.
Step 6
Connect end of disposable set to the patient's
enteral feeding tube (Figure 2-14).
Step 7
RUN/PAUSE
Press the
Display will show programmed rate and the arcs
around the run symbol will rotate (Figure 2-15).
While pump is running, the following may
be viewed by pressing the appropriate
key: Rate, Dose, and
To view the amount delivered in the current
feeding, press the
This counter will reset itself when the previously
programmed dose has been completed and a new
feeding is started, or if a feeding is interrupted
and Rate, Dose or Feed Interval is changed.
To view the amount delivered over the course
of several feedings press the
a second time. Display will read TOTL then the
amount. This counter never resets itself. It can
only be reset by the user (Figure 2-17).
While pump is running, the settings cannot be
changed and the Prime feature is disabled.
If you want to stop pump at any time, press the
RUN/PAUSE
key. Display will show rate, and pump
will be in pause mode. Pump will save the memory
of where it was in the feeding before being paused.
Or, turn pump off by pressing the
FEED INT
key. Pump will begin running.
Feed Interval.
VOL/TOTAL
key (Figure 2-16).
VOL/TOTAL
ON/OFF
key, then
key
key.
17
2. DIRECTIONS FOR USE

Figure 2-13 Clear Feed Interval

Figure 2-14 Connect disposable
set to feeding tube

Figure 2-15 Pump is Running

Figure 2-16 Amount
Currently Delivered
Figure 2-17 Total
Amount Delivered
© Copyright 2022 Moog, Inc.