Figure 2-23 Pump Is Running; Figure 2-24 Amount Currently Delivered; Figure 2-25 Total Amount Delivered - Moog infinity Manuel De L'opérateur

Step 8:
RUN/PAUSE
Press the
running. Display will show programmed rate,
the arcs around the run symbol will rotate and
display will read FEED INTERVAL (Figure 2-23).
While pump is running the following
may be viewed by pressing
the appropriate key: Rate, Dose, and Feed Interval.
To view the amount delivered in the current
feeding, press the
This counter will reset itself when the previously
programmed dose has been completed and a new
feeding is started, or if a feeding is interrupted
and Rate, Dose or Feed Interval is changed.
To view the amount delivered over the course
of several feedings press the
a second time (Figure 2-25). Display will read
TOTL then the amount. This counter never
resets itself, it can only be reset by the user.
While pump is running, the settings cannot be
changed and the Prime feature is disabled.
If you want to stop pump at any time, press the
and pump will be in pause mode. Or, turn pump off by pressing the
When you would like to restart pump, press the
key. Pump will save the memory of where it was in the feeding before stopping.
RUN/PAUSE
Press the
NOTE: Any changes to pump settings during a feeding cycle will cause
pump to start a new feeding; it will not start where it left off.
key. Pump will begin
VOL/TOTAL
key (Figure 2-24).
VOL/TOTAL
key and pump will restart at the point where it was stopped.
key
RUN/PAUSE
key. Display will show rate,
ON/OFF
and/or the
21
2. DIRECTIONS FOR USE

Figure 2-23 Pump is Running

Figure 2-24 Amount
Currently Delivered
Figure 2-25 Total
Amount Delivered
ON/OFF
key.
RUN/PAUSE
© Copyright 2022 Moog, Inc.