Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY STEP 1
PART
TYPE
A
UPRIGHT GUIDE BOLT
B
BOLT
C
FLAT WASHER
D
SPRING WASHER
4
1
A
C
D
B
3
12
HARDWARE FOR STEP 1
DESCRIPTION
M8X1.25PX11L-D10X18.5L
M8X1.25PX80L-20L
8.4X15.5X1.6T
8.2X15.4X2.0T
3
2
B
D
C
A
A
Cut the yellow banding straps and lift the running
deck upward from the rear to remove all contents
QTY
from underneath the running deck.
2
B
Open HARDWARE FOR STEP 1.
8
C
Insert UPRIGHT GUIDE BOLT (A) into MAIN FRAME
8
BRACKET (1) and tighen.
8
Pull the CONSOLE CABLE (2) away from the treadmill
D
base frame. Connect the CONSOLE CABLE (2) from
the MAIN FRAME (3) to the CONSOLE CABLE (2) in the
bottom of the RIGHT CONSOLE MAST (3). The other
end of the CONSOLE CABLE (2) should be located at
the top of the mast.
E
Attach RIGHT CONSOLE MAST (3) to MAIN FRAME (2)
using 4 BOLTS (A), 4 FLAT WASHERS (C) and 4 SPRING
WASHERS (D).
F
Repeat STEP E on the LEFT SIDE.
NOTE: Be careful not to pinch the console cable
while attaching the right console mast.
NOTE: Do not fully tighten bolts until STEP 3.
A
B
C
D
Publicité
Table des Matières
