Re-Using Used Frying Fat - SilverCrest SFG 1900 A1 Mode D'emploi

8.4 Cleaning
Cleaning the frying basket and
lid
The frying basket 3 and the lid 1 can be
cleaned in the dishwasher. If you clean the
lid 1 in the dishwasher, the oil filter 22 inte-
grated into the lid is cleaned simultaneously.
1. Place the lid 1 and the frying basket 3
into the dishwasher.
NOTE: you can also clean these parts by
hand with warm water and detergent. Then
rinse thoroughly with clean water.
2. Let all parts dry completely before you
put them away or use the device again.
Cleaning oil container and deep
fryer
DANGER! Risk of electric
shock!
The oil container 7 is integrated into the
deep fryer 9 and must not be cleaned
in the dishwasher. The deep fryer 9
must not be immersed in water, and
must be protected from water.
1. Use paper towels to remove as much
oil/fat as possible from the empty oil
container 7.
2. Wipe off the oil container 7 and the
housing of the deep fryer 9 with a
damp cloth using a mild detergent.
Make sure that no water gets into the
housing.
3. Then wipe it down repeatedly with a
damp cloth and clean water.
4. Let all parts dry completely before you
put them away or use the device again.
34 GB
All manuals and user guides at all-guides.com

8.5 Re-using used frying fat

1. If you stored the frying fat outside of the
deep fryer 9, it should be melted first
(as with fresh fat) in a pan, before you
fill it into the fryer.
2. If you stored the frying fat in the deep
fryer 9, it must now be heated slowly
and carefully in order to avoid any
splashes.
Let the fryer and the fat stand for a
while at room temperature, until the fat
has reached room temperature.
3. A fork should carefully be punched sev-
eral times into the surface.
4. Put the mains plug into 18 the wall
socket and set the temperature control-
ler 14 to 130 °C.
5. Wait until the fat is melted completely.
Only then should the temperature con-
troller 14 be set to the frying tempera-
ture.
8.6 Storage
DANGER for children!
Keep the device out of the reach of chil-
dren.
• Let all parts dry completely before you
put them away or use the device again.
• Insert the mains plug 18 into its hold-
er 17 on the back of the device.
7
4