SilverCrest SFG 1900 A1 Mode D'emploi page 29

All manuals and user guides at all-guides.com
The lid should be kept closed during
heating and frying.
Hot steam escapes from the oil filter dur-
ing frying. Be careful not to put your
hands into the steam.
Do not touch the hot parts of the device,
e.g. the openings in the lid. The frying
basket should only be touched at the
handle.
After frying, the deep fryer should cool
down for at least 1 to 2 hours before
you empty the oil container and clean
the device.
DANGER of slipping
Avoid any splashes of oil/fat on the
floor. There is a danger of slipping!
DANGER! Risk of electric
shock due to moisture
Protect the device from moisture, water
drops and water splashes.
Do not use the device in the open air or
near vessels filled with water, e.g. sinks.
If the device has fallen into water, pull
out the mains plug immediately, and
only then remove the device from the
water. Do not use the device again, and
have it checked by a specialist work-
shop.
DANGER! Risk of electric
shock
Do not use the device if the device or
the power cable has any visible dam-
age, or if the device has previously
been dropped.
Extension cables must be designed for a
minimum of 10 ampere.
Lay the power cable and any extension ca-
ble such that nobody can step on them, get
caught on them, or trip over them.
Before connecting the device, check that
the on/off switch is set to O.
Connect the mains plug only to a cor-
rectly installed, easily accessible
earthed wall socket with voltage corre-
sponding to the rating plate. The wall
socket must still be easily accessible af-
ter connection.
Ensure that the power cable cannot be
damaged by sharp edges or hot spots.
Do not wrap the power cable around
the device. Use the cable spool on the
back of the device.
Even after it has been switched off, the
device is not completely disconnected
from the mains. In order to fully discon-
nect it, pull out the mains plug.
When setting up the device, make sure
that the power cable is not trapped or
crushed.
To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.
Disconnect the mains plug from the wall
socket ...
... if there is a fault,
... if the device or the power cable is
damaged;
... when you are not using the device,
... before you clean the device and
... during thunderstorms.
Do not connect another device with a
high power consumption to a wall sock-
et on the same electrical circuit. This
way you will avoid overloading the
mains power supply.
Do not connect the device by using a
multiple socket. By doing so the socket
might be overloaded.
In order to avoid any hazards, do not
make modifications to the device.
27
GB