Before First Use; Low-Acrylamide Cooking; Operation; How To Assemble The Handle Of Basket - SilverCrest SEF 2000 A1 Instructions D'utilisation Et Consignes De Sécurité

These can actually ignite when
heating and cause a risk of fire.
Never mix different fats/oils or
old and new fat/oil.
Fully melt solid fat before use.
Note: The oil may be heated
at least up to 200 °C. Make
sure the oil is resistant to high
temperature.
If oil catches fire, it must never
be extinguished with water be-
cause this would lead to a ex-
plosion. You shall extinguish the
fire by putting the lid onto the
product or with a fire or woolen
blanket.
During heating and frying, the
lid must be closed to avoid
1
splash of the hot oil.
Splashes of oil may occur
during heating and frying.
Unplug the product after use or
before cleaning.

Before first use

Remove all the packaging materials.
Clean the product (see "Cleaning and care").

Low-acrylamide cooking

Acrylamide is a possibly carcinogenic substance
formed from a reaction with amino acids when
frying foodstuffs with a high starch content. The
formation of acrylamide increases dramatically at
temperatures of more than 175 °C.
You should therefore avoid frying foodstuffs with a
high starch content, for example chips, at temper-
atures above 170 °C. The foodstuffs should only
be fried to golden-yellow, instead of dark or brown.
This is the only way to achieve low-acrylamide
cooking.

Operation

How to assemble the handle
of basket (see Fig. B1-B3)
Hold and press the handle rods
and inserted into the eyelets on the basket
Release and project the handle rods
the holes of the basket
Put the handle of basket
clicks into place.
Note: Make sure the handle of basket
well attached, otherwise, the basket
fall down and cause injury.
How to assemble the heating
unit and oil container
(see Fig. C)
First, place the oil container
housing .
6
Vertically lower the heating unit
metal housing until the heating unit is well
6
assembled on the two holes of the metal housing.

Heating the frying oil

Note: Never touch the inside
of the oil container
and the metal housing
product while it is operating.
together
4a
3
into
4a
.
3
backwards until it
4
is
4
may
3
in the metal
5
onto the
8
, the lid
5 1
of the
6
GB/IE 25