Stryker MV3 Bariatric Bed Mode D'emploi page 51

E E M M C C i i n n f f o o r r m m a a t t i i o o n n
W W A A R R N N I I N N G G
• Portable RF communications equipment, including peripherals such as antenna cables and external antennas, should
be no closer than 12 inches (30 cm) to any part of M M V V 3 3 , including cables specified by the manufacturer.
• Avoid stacking or placing equipment adjacent with other equipment to prevent improper operation of the products. If
such use is necessary, carefully observe stacked or adjacent equipment to make sure that they are operating properly.
• The use of accessories, transducers, and cables, other than those specified or provided by the manufacturer, could
result in increased electromagnetic emissions or decreased electromagnetic immunity and result in improper operation.
The 5900 M M V V 3 3 Bariatric bed was evaluated using the following cables:
AC mains input cable
AC aux input cable
AC aux output cable
Nurse call (DB-37)
Nurse call (1/4 in.)
G G u u i i d d a a n n c c e e a a n n d d m m a a n n u u f f a a c c t t u u r r e e r r ' ' s s d d e e c c l l a a r r a a t t i i o o n n - - e e l l e e c c t t r r o o m m a a g g n n e e t t i i c c e e m m i i s s s s i i o o n n s s
The 5900 M M V V 3 3 Bariatric bed is intended for use in the electromagnetic environment specified below. The customer or the
user of the 5900 M M V V 3 3 Bariatric bed should assure that it is used in such an environment.
E E m m i i s s s s i i o o n n s s t t e e s s t t
RF Emissions
CISPR 11
RF Emissions
CISPR 11
Harmonic Emissions
IEC 61000-3-2
Voltage Fluctuations
Flicker Emissions
IEC 61000-3-3
The 5900 M M V V 3 3 Bariatric bed is suitable for use in a professional healthcare facility environment and not in environments
exceeding immunity test conditions that the product was evaluated to, such as near high frequency (HF) surgical
equipment and inside of the radio frequency (RF) shielded room of magnetic resonance imaging (MRI) equipment. The
customer or the user of the 5900 M M V V 3 3 Bariatric bed should assure that it is used in such an environment and that the
I I m m m m u u n n i i t t y y t t e e s s t t
5900-009-001 Rev F.1
C C a a b b l l e e
C C o o m m p p l l i i a a n n c c e e
Group 1
Class A
Class A
Complies
G G u u i i d d a a n n c c e e a a n n d d m m a a n n u u f f a a c c t t u u r r e e r r ' ' s s d d e e c c l l a a r r a a t t i i o o n n - - e e l l e e c c t t r r o o m m a a g g n n e e t t i i c c i i m m m m u u n n i i t t y y
electromagnetic environment guidance listed below is followed.
I I E E C C 6 6 0 0 6 6 0 0 1 1 t t e e s s t t l l e e v v e e l l
L L e e n n g g t t h h ( ( m m ) )
2.5
2.5
1.8
2.4
2.4
E E l l e e c c t t r r o o m m a a g g n n e e t t i i c c e e n n v v i i r r o o n n m m e e n n t t
N N o o t t e e - - The emissions characteristics of this
equipment make it suitable for use in industrial areas
and hospitals (CISPR 11 class A). If it is used in a
residential environment (for which CISPR 11 class B
is normally required) this equipment might not offer
adequate protection to radio-frequency
communication services. The user might need to take
mitigation measures, such as relocating or re-
orienting the equipment.
C C o o m m p p l l i i a a n n c c e e l l e e v v e e l l
E E l l e e c c t t r r o o m m a a g g n n e e t t i i c c
e e n n v v i i r r o o n n m m e e n n t t - - g g u u i i d d a a n n c c e e
47 EN