Stryker MV3 Bariatric Bed Mode D'emploi page 19

S S t t o o r r i i n n g g t t h h e e p p o o w w e e r r c c o o r r d d
W W A A R R N N I I N N G G
• Always store the power cord before you transport the product.
• Always store the power cord to avoid the risk of entanglement, damage to the power cord, or potential shock hazards. If
the power cord is damaged, remove the product from service and contact maintenance personnel.
C C A A U U T T I I O O N N - - Do not pinch the power cord in the bed frame.
To store the power cord and auxiliary cord, wrap the cords and secure them with the cord wrap (A) underneath the head
end of the product (Figure 5).
T T r r a a n n s s p p o o r r t t i i n n g g t t h h e e p p r r o o d d u u c c t t
W W A A R R N N I I N N G G
• Always use two people when you transport the product.
• Always store the power cord before you transport the product.
• Always lock the siderails in the full up position with the sleep surface horizontal when you transport a patient.
• Always keep limbs, hands, fingers, and other body parts clear of mechanisms and gaps.
• Always make sure that there are no obstacles near the product. Injury to the patient, operator, bystanders or damage to
the frame or surrounding equipment could occur if you collide with an obstacle.
• Do not attempt to transport the product laterally. This may cause the product to tip.
C C A A U U T T I I O O N N
• Do not use the siderails as a push or pull device. Always move the product using the integrated handles in the
headboard and footboard.
• Always remove the patient helper before you transport the product.
• Do not use the patient helper as a push or pull device.
• Do not use the oxygen bottle holder as a push or pull device.
• Do not use the IV pole as a push or pull device.
• Always make sure that the IV pole is at a low height during transport.
To transport the product:
1. Lock the siderail control panel functions (see Footboard control panel - lockouts (page 28)).
2. Unplug the power cord from the wall outlet.
3. See Storing the power cord (page 15).
4. Lower the IV pole ( Raising or lowering the IV pole (option) (page 38)).
5. Turn the oxygen bottle holder in toward the product.
5900-009-001 Rev F.1
F F i i g g u u r r e e 5 5 – – S S t t o o r r i i n n g g t t h h e e p p o o w w e e r r c c o o r r d d
A
15 EN